E3D Revo™ Nozzles
Bits4bots is an authorised reseller of E3D products
Swap your 3D printer’s nozzles in less than 60 seconds without tools or hot tightening, just use your fingers! If you can unscrew a tube of toothpaste, you can use a Revo Nozzle. Just screw one in to any Revo cold side and you’re ready to 3D print.
Experiment freely. With nozzle swapping this easy, you’re free to experiment with nozzle sizes you might not have used before. Set your 3D printer up for ultra-fine or ultra-thick extrusion widths in no time at all. Print large objects in less time, or tiny objects with high resolution.
Frustration-free. Each Revo Nozzle is a preassembled nozzle and HeatBreak in one unit, so there’s no hazardous hot tightening and no chance of incorrect assembly. Say goodbye to frustrating HotEnd leaks and enjoy reliable 3D printing!
Rapid identification. Identify nozzle sizes at a glance thanks to a colour-coded silicone sock. Plus, each Revo Nozzle has its size engraved into it with easy-to-read numbers, so there are no confusing identification markers to learn!
An expanding range. We’re ready to make RapidChange Nozzles in any size. At launch, we’re introducing brass nozzles in 0.25mm, 0.4mm, 0.6mm and 0.8mm, with many more compatible nozzles to follow later. Wear-resistant and high flow variants are already on our roadmap and will follow over time.
You may need to adjust your Z offset when changing nozzles.
- Material: Brass
- Input diameter: 1.75mm
- Maximum temperature: 300°C
For more information, follow the link below