Refilament PLA+ is essentially regular PLA+ but comes without the plastic spools. Help save the environment by re using your old spools. Use a 5mm allen(hex) key to unscrew an old eSun spool. Otherwise head to the link below for instructions and the STL file to print your own spool. http://www.esun3d.net/products/228.html
You can also buy an eSun reusable spool from the link below https://www.bits4bots.co.nz/products/esun-3d-filament-spool-for-refilament?variant=40524152995995
Biomaterial extracted from corn grain, natural degradable and pollution-free for environment; high rigidity, good gloss and transparency; printing process is non-toxic and tasteless, no curling.
PLA+ has additional additives added into its regular PLA. These additional additives improve the strength of the filament (at least 2 times tougher than regular PLA). PLA has a higher tendency to snap under pressure, where PLA+ is more likely to bend. It also gives a smoother surface finish. PLA+ is also better with dealing with bridging and overhangs so there is less stringing and supports are not required as often.
PLA+ is our best seller as it is a very easy to use filament. You will need to print at a slightly higher temperature than regular PLA. We recommend PLA+ especially for those larger prints.
Advantage: - Neat winding, avoid filament tangle - Reduce the waste of empty spools
|